FREQUENTLY ASKED QUESTIONS
Rapid Set Concrete Mix is a blend of high-performance Rapid Set Cement with quality rock and sand. It provides rapid strength gain, high durability and low shrinkage. Simply mix with water and it will reach structural strength in one hour.
No. The high-performance properties come from the Rapid Set Cement in the mix.
Rapid Set reduces the waiting time prior to coating. Under dry conditions, water-based coatings such as latex paint can be applied after the product is hardened and dry, which usually takes 1 to 4 hours. Solvent based and impermeable coatings such as oil based paint and epoxy can be applied in 16 hours. Experience has shown that some coatings can be applied in much less time. Follow the coating manufacturerӳ recommendations for surface condition.
Bonding agents are not required. Proper surface preparation is the main component in achieving a good bond. If bonding agents are desired, they should be used as a supplement to good surface preparation, not as a substitute.
Blending with other products may give unpredictable results and is not recommended. The use of Rapid SetΠapproved additives and various colors are acceptable.
Any thickness greater than 2 inches.
All Concrete Mix is air entrained except for the product made in California.
Just add water. The use of a mechanical mixer such as a mortar mixer or drill-mounted mixer is recommended. To maximize working time, organize work so that all people and equipment are in place before mixing.
Using traditional methods, place and strike-off to desired level. Rapid Set is fast and does not bleed water so apply your final finish immediately after placing. Organize your tools and people so you can work quickly. On flat work, fill to full depth and proceed horizontally. Do NOT place in layers.
Water cure all Concrete Mix installations. The objective of water curing is to maintain a wet surface until the product has achieved sufficient strength. Begin curing as soon as the surface has lost its moist sheen and continue for a minimum of 1 hour.
Concrete Mix can be used for most concrete applications. Common applications range from fence posts to airport runway repair. Formed work and general concrete repair are the most frequent use.
You can increase the working time by lowering the mix temperature or using set retarding additives. Lower the mix temperature by keeping product cool and using chilled mix water. Rapid Set SET Control additive will increase working time and is available through our Concrete Pharmacy.
Yes. The color of Concrete Mix can be modified by using dry powder pigments designed for use in cement mixes.
Roughen the surface and remove all damaged or contaminated concrete. Make sure the repair surface is not contaminated by oil, paint, acids, dirt or other materials that will prevent a good bond. Immediately prior to placement, saturate the repair surface with water then remove any standing water.
One bag of Concrete Mix yields 0.5 cubic feet. That's one square foot six inches deep. If you need an answer more specific to your application, use our Concrete Calculator.
Yes. Concrete Mix is made with Rapid SetΠCement, which is a hydraulic cement. A hydraulic cement hardens under water.
When stored in a dry location in an undamaged package, Concrete Mix has a shelf life of 12 months.
Cold temperatures will slow the setting time of Concrete Mix and warm temperatures will speed it up. Greater changes in temperature will have a more pronounced effect.